Benchy A300
Copyright Claim
Benchy A300
Boost
55
91
13
Print Profile(2)
0.24mm layer, 2 walls, 15% infill
Designer
1 h
1 plate
0.24mm layer, 2 walls, 15% infill
Designer
4.7 h
1 plate
Boost
55
91
13
0
127
87
Released
Description
Hop on board and take to the air… or the sea??
With our new patented Benchy A300 from UseLess engineering you can have the best of both worlds soring over the Atlantic or in the event of an engine failure we can sail.
Back to real land, the model needs supports to print properly, I have included them in the bambu studio file but if you are printing from the raw model I used supports on the bottom only and you should too. I have also included a model that uses 4 colours - silver, white, red and green. you are welcome to use any colours, its all a bit of fun. Have fun printing you silly engineers.
UseLess Engineering
Comment & Rating (13)
All
Print Profile
0.24mm layer, 2 walls, 15% infill
very nice addition to the aviation section
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
Nice model but wish I printed it in 0.16 rather than 0.24 so that it had more detail.
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
Took long but came out very well. 👍
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
I love my benchy
(Edited)0
Reply
Weeeeeeee——BOOM！It‘s funny！
0
Reply
great！
0
Reply
that’s really funny :D
0
Reply
Good love it
0
Reply
それわとでも面白いものですね
0
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld