New York Brooklyn Bridge Hueforge
Boost
57
93
11
Print Profile(3)
0.08mm layer, 3 walls, 100% infill
Designer
9.6 h
3 plates
0.08mm layer, 3 walls, 100% infill
Designer
10.5 h
3 plates
0.08mm layer, 3 walls, 100% infill
Designer
7.3 h
3 plates
Boost
57
93
11
1
119
74
Released
Description
Are you looking for a painting of New York? Here you go! It can be assembled by joining the parts or spacing them a few centimeters for an even better result.
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA Geetech Black Transmission Distance: 0.5
PLA Geetech White Transmission Distance: 6
Swap Instructions:
Start with Black
At layer #11 (0.96mm) swap to White for the rest.
DO NOT TOUCH THE Z HEIGHT!
Comment & Rating (11)
All
Boosted
Print Profile
0.08mm layer, 3 walls, 100% infill
i scaled them up as big as i could. i must of got one a bit off because it doesn't quite line up. but it is great. thanks.
Edit - Looking at the example, the right panel looks to be off on yours too.
(Edited)
0
Reply
can you print this or make it possible to print on the P1S please.
The designer has replied
0
Reply
yes, I have added!
0
Reply
Replying to @fabiuscom
thank you. 👍
0
Reply
Print Profile
0.08mm layer, 3 walls, 100% infill
amazing. can't wait to go see it for real.
1
Reply
This is not the Brooklyn Bridge. It is quite literally the opposite of the Brooklyn Bridge. It's the Manhattan Bridge.
0
Reply
Print Profile
0.08mm layer, 3 walls, 100% infill
mega, gerne mehr davon
0
Reply
Print Profile
0.08mm layer, 3 walls, 100% infill
nickel
0
Reply
how were you able to split it into 3 images?
(Edited)0
Reply
Print Profile
0.08mm layer, 3 walls, 100% infill
0
Reply
Print Profile
0.08mm layer, 3 walls, 100% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoDerivatives
© 2024 MakerWorld