No Print Profile yet. Add one to earn points.
This ‘Print in Place’ fidget toy is a simple joinery based model.
Hold her and make her head / hair spin. A funny and a little bit disturbing but a different fidget toy.
Filament : PLA
Layer Height : 0.2mm
Infill : 15-20% , you can make the hair heavier too.
No supports required
Some post processing required - You can color the model or use AMS / MMU whichever you have to get a colored model.
I don't have the AMS or the MMU so was not able to print it in multiple colors but I have used a sliced model as an example. Don't forget to color the eyes and the smile hidden below the hair.
Hope you enjoy!