A1 Honey Bucket by VandalBee

VandalBee

3D Printer>3D Printer Accessories

Print Profile(2)

All

0.16mm layer, 2 walls, 5% infill

Designer

3.8 h

1 plate

3.0(2)

0.2mm layer, 2 walls, 15% infill

3.5 h

1 plate

4.9(9)

Boost

124

Released

Description

Honey Bucket designed specifically for A1 with only 69g of filament needed to print.

I made this slick design as I'm limited in X space. The model is approximately 180mm x 90mm.

Slides into the A1 frame for better security.

Note: My A1 is lifted on anti-vibration pads. Otherwise, the model height is designed to flush with the base of the bed.

Perfect with combination with

A1 mini poop baffle by 小樹 - MakerWorld

Bambu Lab A1 mini Purge Guide, Baffle, Deflector Remixed by thrutheframe - MakerWorld

a1 accessories

a1 bambu lab poop bucket

Comment & Rating (18)

@Big_Bear

My honeycomb keeps failing....this pic is what I saw when I returned from store after starting print. Brand new A1 and have printed many thing with same filament roll. Sunlu PLA silk.

(Edited)

The designer has replied

@slucid

same here

@VandalBee

What seems to be the issue? I did not have any troubles printing it. Could you share some pics so I can take a look?

@VandalBee

Thanks for sharing the picture. I double checked the profile and found that the slow down for overhangs was disabled. This is most probably what caused the issue. I use Orca and I must have messed up when porting to Bambu Studio. I just uploaded an updated profile. I will print it again to double check. I apologize for the inconvenience.