Legend of Zelda Triforce LED Lightbox by MFDesigns3D

MFDesigns3D

Art>Signs & Logos

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 3 walls, 15% infill

Designer

6.6 h

2 plates

4.9(19)

Boost

139

162

113

Released

Description

I made this Triforce LED Lightbox for a superfan.

Be sure to check out my profile to get my other designs!

Comment & Rating (26)

@ME3D

Print Profile

0.2mm layer, 3 walls, 15% infill

profile is good. user error on my end, will upload picture of good print once it’s complete

(Edited)

The designer has replied

@MFDesigns3D

First off, I just looked at your pic. Those issues look like you're having heavy wisping. You're getting black filament hairs blended in with the yellow. I suggest you run your filament through a dryer. It has nothing to do with the profile. Here's a pic of mine proving it's a solid profile. Second...You'll notice that this model is listed as non-commercial. These are for personal use not for resale.

(Edited)

@MFDesigns3D

Replying to @ME3D :

Take a look through the comments. Lots of pics of perfect prints. The issue is your filament, not the profile.

@ME3D

Replying to @MFDesigns3D :

I’ll take a look at it

@IDontKnow1988

Print Profile

0.2mm layer, 3 walls, 15% infill

Thank you

@stationroadrat

Made for my wife, she loved it! I resized it to fit the biggest I could on the pad, and trimmed with a small dremel tool to fit a USB-A cable. I had to turn the initial filament speed down to 50mm/sec for it to adhere to the pad properly, but after getting that sorted the print was perfect.

(Edited)