When I first started using my Bambu Lab X1 Carbon over a year ago I had an idea to replace the door handle with one that looked like cut bamboo. One that kind of replicated the Bambu Lab logo. Well I finally got around to designing one.

I printed the bamboo door handle using PETG but any filament should work. No supports are necessary. I used the default settings for the “0.16mm Optimal @BBLX1C” system preset except for the following:

Quality > Seam : Back

Strength > Walls : 3
Strength > Sparse infill > Sparse infill pattern: Gyroid

Use the same screws used with the original door handle.

Warning: Be careful when you screw on your new door handle in that you don't over tighten them as you may crack the glass. Make sure that the tiny washers are still on both sides of the screws.