No Print Profile yet. Add one to earn points.
This is a 7.4 to 8.4 gage to set your inductive sensor heights when upgrading your CR10s Pro if you have a steel or flex plate bed. This gage have multiple steps with 0.1mm increments so it's obviously best to print it at 0.1 or less.
I followed this tutorial: https://youtu.be/VH3zrRNOGfA and quickly found out that my sensor was triggering at its nominal value of 8mm because I have a wham Bahm flex plate installed.
I found that my sensor is working well set at 7.8mm, that gives me a Z offset of -0.04mm and it is now very stable and gives me perfect first layers everytimes.
This is the sensor I'm using: http://tinyurl.com/y5zeo8nl
Printer Brand:
Creality
Printer:
CR10S PRO
Rafts:
No
Supports:
No
Resolution:
0.1
Infill:
20%