Clothes Dryer / Airer Feet Protectors
Clothes Dryer / Airer Feet Protectors
Print Profile(1)
Description
My clothes dryer/airer lost its original feet protectors and I found the sharp edges of the metal were digging into our new carpet. As it's always setup in the same place I was worried it would very soon wear a hole, so I designed these feet for it.
They have a large 20mm base to prevent it from sinking into the carpet. They have a hole that will accept up to a 5mm bar size.
If your bar is very slightly smaller, a few wraps of electrical tape around the end will allow you to achieve the perfect fit.
I would highly recommend printing in TPU to allow a small amount of flexibility to ensure you are able to get them on.
No Supports Required
I do have a Larger size available here: https://makerworld.com/en/models/57806#profileId-59508
Comment & Rating (0)
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
