Cable Chain and PTFE Tube Protection
Copyright Claim
Cable Chain and PTFE Tube Protection
Boost
148
375
106
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
14 min
1 plate
Boost
148
375
106
1
488
387
Released
Description
Screw Protection for Cable Chain and PTFE Tube on Bambu Lab Printer P1 and X1 Series.
When you are printing on the right side of the bed, the PTFE Tube and the Cable Chain are rubbing against case screws with hard/sharp edges. This simple model saves your Printer from wear in that area and also removes that freaking sound when the PTFE Tube rubs against the screw from the top. It´s only 2g of filament and no supports.
The Protector is designed to be Press-Fit, you need some force to get it into place, It is tight - so it does not go anywhere after putting it into place. To remove, grab the top part and add some force again 🤣.
Remarks:
It was reported that newer versions, have problematic parts already covered with foam tape.
I hope you enjoy the design, please leave a comment/rating if you enjoy it or share your feedback!
Comment & Rating (106)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
perfect print
1
Reply
great print! but stuck pretty good on the build plate.
(Edited)
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed in asa, came out great
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
perfekt
1
Reply
Ich hoffe es funktioniert genauso gut wie es zu installieren ging.
Vielen Dank
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
perfect
(Edited)
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Fits perfect and looks good
(Edited)
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Great print, using PETG
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
top! Thanks 🙏🏿🙃
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Easy to print. Fits tight and well
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
© 2024 MakerWorld