Cable Chain PTFE Clip with Zip Tie! For X1 and P1 series
Copyright Claim
Cable Chain PTFE Clip with Zip Tie! For X1 and P1 series
Boost
8
21
6
Print Profile(1)
0.2mm layer, 4 walls, 15% infill
Designer
20 min
1 plate
Boost
8
21
6
0
49
16
Released
Description
I tried to design a better cable chain PTFE clip after finding the ones I was using kept slipping after a while, because they get loose over time.
Mine has a zip tie to keep it tight.
The zip tie should go on the inside of the curve. You don't have to make it gorilla tight. This clip is going nowhere.
I also made the top area where the PTFE tube rides a little bit wider to give the tube a bit more freedom which prevents pulling as much.
Happy Printing!
Comment & Rating (6)
All
Print Profile
0.2mm layer, 4 walls, 15% infill
works perfectly! don’t have to worry about those guides falling off again!!
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
endlich keine Probleme mehr! Wieso kommt es nicht gleich von Bambu so? :)
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
Strength Issue:while removing the brim some broke down
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
Related Models
© 2024 MakerWorld