Fidget Sphere - Rotating Ball Fidget Toy
Copyright Claim
Fidget Sphere - Rotating Ball Fidget Toy
Boost
25
53
23
Print Profile(4)
Fidget Sphere 0.2mm layer, 2 walls, 15% infill
Designer
26 min
1 plate
Best for Silk Filament 0.16mm layer, 2 walls, 15% infill
Designer
31 min
1 plate
Keychain Version 0.2mm layer, 2 walls, 15% infill
Designer
26 min
1 plate
Bottom Fillet for a smooth edge 0.2mm layer, 2 walls, 15% infill
Designer
26 min
1 plate
Boost
25
53
23
1
113
215
Released
Description
Fidget Sphere - Rotating Ball Fidget Toy
Note: The sphere will need a little bit of force to snap then it can move freely.
If using silk filaments i would suggest the 0.16mm profile as its easier to break free by hand
How to use: Hold the fidget in your hand and roll with your thumb or roll it in your palm or spin it as fast as you can
Comment & Rating (23)
All
Print Profile
Keychain Version 0.2mm layer, 2 walls, 15% infill
After loosening the ball and spinning it around for a bit the ball spins freely and works as it should
1
Reply
sad
0
Reply
Print Profile
Fidget Sphere 0.2mm layer, 2 walls, 15% infill
the ball didn’t spin well in the fidget.
(Edited)The designer has replied
0
Reply
Thanks for your feedback I would suggest pushing on it and then twisting to break it free it will then need a few minutes of pressure on it while spinning it around and then it should start to feel a lot smoother and spin more freely. Silk filaments seem to work better and feel more free
(Edited)1
Reply
Replying to @PrinttX
Thanks--it did loosen up a bit and spins pretty good now!
0
Reply
Print Profile
Fidget Sphere 0.2mm layer, 2 walls, 15% infill
Printed a few to give away as little gifts, great responses from the recipients so far. Have used a mix of Bambu Silver PLA for the body and Generic Tricolour Silk PLA for ball. Works well and the tricolour gives and interesting spin look.
1
Reply
Print Profile
Fidget Sphere 0.2mm layer, 2 walls, 15% infill
the top part of the fidget turned into spaghetti :/
0
Reply
Print Profile
Fidget Sphere 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
Fidget Sphere 0.2mm layer, 2 walls, 15% infill
0
Reply
Boosted
Print Profile
Best for Silk Filament 0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
Fidget Sphere 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
Best for Silk Filament 0.16mm layer, 2 walls, 15% infill
(Edited)
Other Issues:when you take it off the bed it is impossible to move
0
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld