Modified 2, 4, and 6 Tower with no bridging (Chamfers Added on undersides)

Remixed by

Modified 2, 4, and 6 Tower with no bridging (Chamfers Added on undersides)

Remixed by
Boost
0
2
1

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.2mm layer, 2 walls, 20% infill
0.2mm layer, 2 walls, 20% infill
Designer
5.7 h
1 plate

Boost
0
2
1
0
11
0
Released

Description

I added chamfers to the inside bridging surfaces so no supports are needed or the risks of bridging failure and having layer shifts or knocking the part loose.

Comment & Rating (1)

Please fill in your opinion
(0/5000)

The original model is licensed CC-BY-SA (without NC/non-commercial). A derivative is not allowed to add additional restrictions, such as NC, when the original license specifies SA/Share-Alike. See https://creativecommons.org/licenses/by-sa/4.0/ which says: "If you remix, transform, or build upon the material, you must distribute your contributions under the same license as the original." and "You may not apply legal terms or technological measures that legally restrict others from doing anything the license permits."
(Edited)
0
Reply
No more