I have sliced and added pegs so i can be placed top down on the build plate allowing the pattern from your build plate to be transferred to the visible shelf.
Print was poorly made. The pattern isn't as good as expected and additionally the pieces can't be attached together properly. Overall it was a complete waste of filament and time.
Problem wasn't the plate. It was the seams. And legs didn't end up being consistent height. And pegs didn't print properly either. This is using P1S in a controlled environment.
thank you for your feedback, I will revise the first lay pattern, this will resolve the seams.
the legs and pegs I've not experienced that issue so not sure how to resolve I print on a p1p no enclosure
Works well, not sure about the pins they seem a bit small to hold much and are a tight fit to the holds. I will probably design a clip to hold the tiers together.
The stand itself printed without any problem. One of the little pins got lose from the printbed so this was one mistake at my end. The pins was printed properly didnt fit at all, so i have to use some super glue. The stand looks pretty good.