I needed a label roll holder for my thermal label printer, and the ones I found online would take too long to print for my taste.
The version I uploaded has a slight rib under the spool to increase rigidity, so it'll look slightly different from the photo.
This will hold a standard 500-label roll of 4x6 labels. There is a version with a tab to keep the stand 50mm from the printer, and a version without it.
Printer Brand:
LulzBot
Printer:
TAZ 5
Rafts:
No
Supports:
Yes
Resolution:
0.32mm
Infill:
15%
Tree Green
Notes:
I printed the hub on end with supports, and the stand right-side-up with supports as well.
I used a 0.45mm extrusion width, two perimeters, and three floors/ceilings.
You could print at a higher resolution, but there's really no need.