Printed this bad boy - print came out good. I used PLA on the P1S. Additionally - note that this will not work with the standard AMS parts. I am printing a space to make it work though. You will need a new bolt that is ~15 mm longer than the stock (stock is ~20mm). The part I made is simple - using Bambu Studio make a cylinder 13x13x10. Add a negative part/cylinder at 0,0,10 with dimensions 4x4x25. I made my 20% infill for some added strength against the tightening forces.

I have an Esun EBOX LITE....wonder if this would fit???

If I made the original right side mount would it be possible to only print the the piece that goes around the back and have them fit together?

works well

Awesome print - doesn't fit stock buffer - space instructions in comments.

Thank you so much for making this!