0.2mm layer, 3 walls, 85% infill (can printer higher infill, but 85% works well for me)
Designer
1.3 h
1 plate
5.0(6)
Boost
10
27
7
2
26
47
Released
Description
Hard hat hanger for the headrest post of a front seat in most vehicles. Keeps my hard hat right where I need it and out of the way. Highly recommend printing in at a minimum PETG (hotter areas will probably want to use ASA or ABS).
0.2mm layer, 3 walls, 85% infill (can printer higher infill, but 85% works well for me)
I found that my vehicle headrest cannot come out so I Can’t use this item like I hoped I would, but I’m still giving five stars because it’s a solid Print!