Wavy Boxes Won't Warp - Not Vase Mode
Copyright Claim
Wavy Boxes Won't Warp - Not Vase Mode
Boost
15
22
1
Print Profile(3)
Square Box
3.9 h
1 plate
Small Box
1.4 h
1 plate
Long Box
4.6 h
1 plate
Boost
15
22
1
0
60
29
Released
Description
These boxes are very flexible and will not pull off the bed like other large box prints.
- You can set seams to RANDOM to prevent a weak spot.
- You can use vase mode but it's weak- these print with 2+ perimeters solid.
Comment & Rating (1)
All
Print Profile
Square Box
it printed awesomely. i scaled up the square size to fully cover the 256mm plate of my A1. then i sliced a few inches off the top because I didn't need it super tall/deep, i only needed it super wide and long. i used .8 nozzle with .56 layer height and .82 layer width and that trimmed off a few hrs of print time compared to a .2 layer height. it's super convenient to hold my print models until i distribute them to family as gifts 😄😊👍
(Edited)
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Share Alike
© 2024 MakerWorld