Good simple design with no more filament used than just needed.
Took me 2 tries to print, properly my filament condition, broke in hinges. Swapped filament but had the feeling it was about to brake but thankfully did not. :)
I'm a noob in this world, I printed this two times because the first time the tolerance was not adjusted. Finally I could finish this design easily but this time i have got much stringing, I only changed the layer height from 0.2 to 0.32. Can anybody tell me if this problem is caused by the layer height? thank u.
It works but I think the adjustment grooves on the back could be deeper. The second I pick up my phone, the thing falls over. I ended up tossing it in the scrap pile and making a different design. It looked cool though.