Pegasus
Copyright Claim
Pegasus
Boost
14
20
12
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.5 h
1 plate
Boost
14
20
12
0
45
24
Released
Description
Pegasus is a winged horse in Greek mythology.
Comment & Rating (12)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
the design idea was nice buy there was way to many supports for the thin legs and wings and it just started snapping apart. I even tried to be gentle. bums me out cause I had plans to intricately paint it
The designer has replied
0
Reply
That's a shame you had problems. I intend on improving the print. Thankyou for your helpful comments.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Support Issue
The designer has replied
0
Reply
Please advise what the issue was with the supports.
0
Reply
Replying to @beamr39
Support on tail broken during printing.
0
Reply
Thankyou for the information.
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
Thankyou
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
Thankyou😊
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Strength Issue:It was too delicate in the legs.
Support Issue
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Support Issue:too much of the supports and to hard to remove
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld