eSun official cardboard/paper spool adapter from eSun Original
Remixed by
Copyright Claim
eSun official cardboard/paper spool adapter from eSun Original
Remixed by
Boost
16
35
31
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
46 min
1 plate
Boost
16
35
31
1
196
440
Released
Description
This spool adpater was created by eSun itself for the Cardboard spools, work with old AMS versions
Dont work with SA0001 for this use the Lid raiser
use https://makerworld.com/de/models/33133#profileId-29934 or https://makerworld.com/de/models/24099#profileId-21342
Printed with Pla+ profile from eSun website for X1C
https://www.esun3d.com/zldownload_catalog/filaments_printing-settings
eSun gave me permission to share it with you :)
Comment & Rating (31)
All
does not work with ams. can use height raiser for ams, but it then fell off 2x during printing.
The designer has replied
0
Reply
i have used the linked ams lid raiser
0
Reply
Replying to @Dreistmann
I use a riser. falling off during the print was the major issue. found a different one that works better. has the tabs to go in the holes and that keeps it solid on the spool
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
falls off ESUN spools and requires a riser in the ams box. contacted ESUN about this and was told they are working on something.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
leider haben keine Rollen damit mehr Probleme gemacht als ohne, es gab immer beim zuführen und beim aufwickeln hat die Rolle nicht schnell genung das Material aufgenommen und dann kam es zu einer Störung
der Druck an sich war jedoch gut!!!
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
After printing a ton of adapters which didnt fit, found these which fits and prints just Perfect 😊
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed clean and worked well, NOTE: the roll dimensions can change even from one side to the other, This fits one side nice and tight, Perfect fit! but is too small for the other side. so had to increase the diameter by 2 mm to fit the other side. Dont forget to print the riser if you are using AMS.
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
nice
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
it done not fit the cardboardsool, it fals of
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed well but I still ended up ripping the cardboard sides of and used printed sides and Bambu reusables.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
it’s too small to fit my esun cardboard spool.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Fits perfect, easy to print and mount.
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld