Summary

This is a remix of rolo12 Makarov Pistol display stand.
I have a replica of this pistol and want a proper place to show it.
For this model I erased the bullet holes and modified the base profile to adapt to other gun stands I have.

Print Settings

Printer Brand:

Creality

                                            Printer:                      
Ender 3 Pro

Rafts:

                                            Supports:                      
No

Resolution:

0.2

                                            Infill:                      
20%

Filament:

Winkle PLA

                Ebony                    
                        Notes:                     You don't need supports if you print it in two pieces.

You can already try to print the full model without supports but I prefer to print the vertical part flat to avoid height and adhesion problems.

For stand_2.stl make sure you have "Outer Before Inner Walls" deactivated in your slicer (it is normally deactivated on Cura) because it will try to print the round corners in the air.