22LR Ammo Case - 100 Rounds
Copyright Claim
22LR Ammo Case - 100 Rounds
Boost
23
45
26
Print Profile(3)
22 LR Slider V2
Designer
1.8 h
1 plate
22LR Slider V1
Designer
1.8 h
1 plate
Just Tray Insert - Tighter Insert for v1
Designer
38 min
1 plate
Boost
23
45
26
2
109
219
Released
Description
11-11-2023
- Added v2 with tighter tolerances
- Added tighter tolerance insert for those that just need tighter insert after printing v1
.22 LR ammo case that holds 100 rounds
If the tray doesn't fit snug: Place a drop of superglue on each post and then press the tray onto the posts. Let the glue fully dry and before placing ammo inside, or before sliding the lid on. This is to prevent any superglue residue or “bloom” from getting on your ammo and lid.
If lid it too loose/tight when sliding you can scale the Y-Axis up/down by 0.2. If you do this make sure that Uniform Scale is NOT checked and only the lid is selected.
Comment & Rating (26)
All
Print Profile
22LR Slider V1
inert could be a tad bigger for a tighter fit
The designer has replied
0
Reply
Thanks for the feedback. Do you mean the entire insert itself is a tad small, or the holes are too small? Let me know and I'll upload a fix.
(Edited)1
Reply
Replying to @KiCkiN
the insert has a tad bit of slack each direction
(Edited)1
Reply
Replying to @Shawn_standridg
Gotcha. I just put glue on top of pylons or whatever youd call the posts that the insert sits on to hold the insert in place. But I'll upload a tighter fit insert sometime tonight.
0
Reply
Print Profile
22 LR Slider V2
Wanted to love this, but my husband pointed out that if you tip it the lid will just slide right off.
The designer has replied
0
Reply
It should fit tight, but can vary based on filament settings.
0
Reply
Print Profile
22 LR Slider V2
turned out great
0
Reply
Print Profile
22 LR Slider V2
Strength Issue:holes need more strength. thin and may break
0
Reply
Print Profile
22 LR Slider V2
Nice simple design
0
Reply
Print Profile
22 LR Slider V2
A functional print. Shell holder tray had a few off strings, but I was about to clean it up. I will print again. Thanks!
0
Reply
Print Profile
22 LR Slider V2
superbut the top conector are realy thin, i scared it will be broken
(Edited)0
Reply
Print Profile
22 LR Slider V2
Lid is to lose can’t make adjustments from Bambu handy.
(Edited)0
Reply
Print Profile
22 LR Slider V2
0
Reply
Print Profile
22 LR Slider V2
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld