Bambu A1 mini Ams lite wall or ikea skadis mount by Raidol

Raidol

3D Printer>3D Printer Accessories

Print Profile(2)

All

P1P

P1S

X1 Carbon

X1E

A1 mini

0.2mm layer, 6 walls, 25% infill

Designer

2.9 h

1 plate

4.5(17)

0.2mm layer, high strength, 25% infill

Designer

3.3 h

2 plates

4.8(11)

Boost

213

341

491

180

Released

Description

Hi everyone!

I have created this file because I needed to free up space on my desktop. So I have created a support for the wall that could also be compatible with the IKEA Skadis noticeboard.For smaller print beds, I have split the base into 2 pieces. For those like me who also have a 3d printer with a larger working area, it can print in one piece.As hardware you only need 4 pins and 2 M5 bolts.Let me know if you like it and if the file needs modifications.

Bye everyone

RAIDOL

Comment & Rating (60)

@KaiBachmann

Print Profile

0.2mm layer, 6 walls, 25% infill

Sehr gut gemacht.

@mb_creating

Was ist eine "Pin" auf Deutsch? die man in Obi / Hornbach / Bauhaus finden kann. Danke!

@gretsky44

I printed the split file made for the A1 Mini printer. Worked great. It reduced the depth of my vertical mount system by about 4 inches. My L shaped base lets me keep the A1 Mini and AMS portable as 1 peice, incase the wife makes me move out of this room. Thank you for sharing the design with us.

The designer has replied

@Raidol

It makes me very happy!

@Fr3chdaxx

What length of the M5 screws is required? and which pins do you think are still needed?

The designer has replied

@Raidol

The bases where the pins go are 8mm thick, the skadis board is 5mm. I used 16mm long pins. Even just the 2 upper pins could be enough, but for greater stability I preferred to use 4

@Fr3chdaxx

Replying to @Raidol :

OK, all clear, thank you for the information. I'm currently in the process of printing it. I took the second profile from you where both are on one disk and it only takes almost 3 hours. I'm excited to try putting it on the wall this evening

@Raidol

Let me know if you find anche errori in the file or if you have anything else to report. I hope you find yourself well. Update me and send a photo if you can.

@mapr

Print Profile

0.2mm layer, 6 walls, 25% infill

A good support, I would improve the screw holes, they do not hold well. Good job.

@Badio

Print Profile

0.2mm layer, high strength, 25% infill

it's perfect! thank you so much!

@rubiks

Works well. Thanks.

@waltersworld3d

Print Profile

0.2mm layer, high strength, 25% infill

do what they say they do!!

@mm.med

I printed out this model (in two parts) which I find interesting. But I have a big problem with it: it's not strong enough and is only held in place by the two support screws on each side, which don't fit sufficiently into the ams. I enlarged the diameter to 6 so the screws would fit better. I also drilled and added two screws for extra rigidity. I should have made it much thicker and recessed the screws. I'm not too confident about the strength of 4 full coils. I've also turned the Ams upside down to avoid extending the cable.

(Edited)