Print Profile(2)
0.2mm layer, 4 walls, 10% infill
Designer
10.6 h
1 plate
0.2mm layer, 4 walls, 10% infill
Designer
10.4 h
1 plate
Boost
32
32
4
0
305
14
Released
Description
Español
Maceta con forma de torre de castillo. Especial para plantas pequeñas como Suculentas, pequeños aloe vera, hierbas aromaticas, etc.
Lleva unos pequeños agujeros en la parte inferior para que el agua sobrante caiga directamente al foso.
Muy facil de imprimir.
English
Flowerpot shaped like a castle tower. Special for small plants such as Succulents, small aloe vera, aromatic herbs, etc.
It has small holes at the bottom so that excess water falls directly into the pit.
Very easy to print.
Comment & Rating (4)
All
what filament was this done with
The designer has replied
0
Reply
With Sakata brand granite filament
1
Reply
Print Profile
0.2mm layer, 4 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 10% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld