This is a height-customizable spool rod that is compatible with the Flashforge Dreamer's standard spool holder. It is also compatible with @BaronWilliam's Top Mount and Internal Side Mount Omnistands.

I designed this to be used with my Universal Spool Hub.

If you are using this rod inside the Dreamer, the max height (aka length) of the rod should be 90 mm. If you are using this outside the printer, then I would suggest a max of 125 mm. The axle diameter is 19 mm.

Print Settings

Printer Brand:

FlashForge

Printer:

Rafts:

No

Supports:

Resolution:

0.2

Infill:

Notes:

Since this rod is intended to hold 1 kg spools, you want a high infill percentage. I printed with 75%.

Although you could print this vertically, I recommend printing it lying down on its side (lengthwise going left <-> right). This would allow for best strength. A vertical print would more easily snap in half due to layer separation risk. If you print it lying down on its side, you will need to use supports.

Category: 3D Printer Accessories