Cracked Mjölnir for glowing cracks! Love and Thunder Hammer.

You are worthy to possess the power of Thor!

SCALE 1:1
BIG HAMMER

I printed this Love and Thunder Hammer in one piece, full with disk.stl, open side up. Only with some supports under the disc and the internal cylinder where the handle is inserted. I then printed the top side and the handle. Easy peasy

You can print the hammer in translucent filament and then paint the outside silver except for the cracks, put a led inside and you will have glowing rays!

You can stick magnets on the top side if you are going to put a led inside.

I also added a version without a disk in case you want to put magnets on top. And two disc designs with the Nordic runes. Sköll!

-Layer Height 0.2mm
-Walls 3
-Infill 15-20% Gyroid
-Speed: 60mm/s Walls: 30mm/s
-Retraction: 6.5mm @ 25mm/s
-Supports Yes, only below the disk and the little cylinder inside if you choose the Full with disk.stl