A gift card lock box perfect for gifting store cards, vouchers, cash, Keys or anything else you can fit inside!

Probably the fastest printable lock box on Makerworld!

Features:

• Prints in under 2 hours (2 colour)
• 14 thumb screws secure the box shut.
• No additional parts are needed for assembly.
• Print in place hinged design
• Satisfying to open and close
• A fun way of giving someone more than just a generic gift card.
• Perfect for Birthdays, Weddings, Christmas or any other occasion that involves giving gifts :)
• The Box, Lid and Ribbon Strips are interchangeable with my ‘Annoying Version’ (See below)

Assembly/usage:

After printing all parts-

• Insert your gift of choice into the smaller half of the box.
• Close the box
• Assemble the ribbon strips in the cross pattern
• Poke the ribbon strip screw through both holes in the ribbon strips and hold in place with your finger
• Offer up the ribbon strips to the lid of the box and locate the centre screw
• Tighten the centre screw with the tips of your fingers until the ribbon strips are snug
• Insert all 14 screws around the outside of the box.

Extra Info:

• The centre screw has no purpose except holding the ribbon strips in place, so the box can be opened with it in place.
• The print profile for the A1 mini has the main box separated into 2 parts. This doesn't affect anything and the two parts can simply be pushed together at the hinge, after printing. This should be very obvious when you have the parts in your hands.

Please post your makes and rate your experience :) It's very much appreciated :P

The annoying version of this gift box, is out now! ;)

(Click the picture)