This case is designed to hold a Kobo nia and a bluefly vario version 12.2

The case can be printed without any supports.

The case pictured is printed in PETG

It is suggested to use some sort of foam in the bottom of the case to avoid rattling. In this case, double-sided tape was used with the cover left on to take up the extra space. The Bluefly Vario was taped in to avoid ratling.

The lid is to protect the screen during storage. The lid can be a bit tricky to get off, but if you start by lifting near the cutout for the USB charger it can be lifted off easily enough.

The screws are m3, with metal inserts. If there is a desire for a redesign without the screw inserts, and just screwing into the plastic let me know.

There are 2 small holes on each side of the case for a tether.