AMS Riser Rear Honeycomb Panels - for maCyo42 remix
Remixed by
Copyright Claim
AMS Riser Rear Honeycomb Panels - for maCyo42 remix
Remixed by
Boost
62
166
77
Print Profile(1)
0.2mm layer, 6 walls, 15% infill
Designer
1.7 h
1 plate
Boost
62
166
77
0
423
308
Released
Description
Simple push in honeycomb panels to finish off the rear of the AMS. I didn't like that it was open so designed these. These only fit the maCyo42 remix of the AMS Riser, they DO NOT fit the original benlevi design.
Comment & Rating (77)
All
Print Profile
0.2mm layer, 6 walls, 15% infill
¡Genial!
The designer has replied
2
Reply
Thank you for your review!
0
Reply
Print Profile
0.2mm layer, 6 walls, 15% infill
Perfect. Thank you.
The designer has replied
1
Reply
Thanks for the rating
0
Reply
Print Profile
0.2mm layer, 6 walls, 15% infill
fits well the back of the riser
The designer has replied
1
Reply
Glad you like it
0
Reply
Print Profile
0.2mm layer, 6 walls, 15% infill
Came out great on textured PEI plate. Snapped right into the maCyo42's BLV AMS Riser Remix 🤘🏻
The designer has replied
1
Reply
Glad you like them and thanks for the feedback
(Edited)1
Reply
Print Profile
0.2mm layer, 6 walls, 15% infill
Fits Perfectly
0
Reply
Print Profile
0.2mm layer, 6 walls, 15% infill
great to fill empty space at back
0
Reply
Print Profile
0.2mm layer, 6 walls, 15% infill
snadný tisk, díky 👍
0
Reply
Print Profile
0.2mm layer, 6 walls, 15% infill
very nice print
0
Reply
Great print and perfect fit! Thank you!
0
Reply
Print Profile
0.2mm layer, 6 walls, 15% infill
looking good 😁
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
© 2024 MakerWorld