Funnel for PTFE tube - Simple filament feeding for Bambu Lab
Copyright Claim
Funnel for PTFE tube - Simple filament feeding for Bambu Lab
Boost
16
42
12
Print Profile(1)
OFFICIAL - 0.2mm layer
Designer
24 min
1 plate
Boost
16
42
12
1
78
56
Released
Description
Makes it easy to insert filament into the printer's PTFE tube.
Ideal for Bambu Lab P1P, P1S, X1, X1C ecc. but also great for all other printers.
Comment & Rating (12)
All
Print Profile
OFFICIAL - 0.2mm layer
very usefull
0
Reply
Print Profile
OFFICIAL - 0.2mm layer
(Edited)
0
Reply
Print Profile
OFFICIAL - 0.2mm layer
This model is great. Nothing to complain about it.
But. There is a "but". ...when using TPU I'm having an hard time passing from the funnel to the PTFE tube.
Sometime is so frustrating that I remove the funnel, inserti the TPU through it, then insert the TPU inside the PTFE tube and then place back the funnel on the PTFE tube. Sometime this happens with PLA too, but moving it solves.
0
Reply
This model is great. Nothing to complain about it.
But. There is a "but". ...when using TPU I'm having an hard time passing from the funnel to the PTFE tube.
Sometime is so frustrating that I remove the funnel, inserti the TPU through it, then insert the TPU inside the PTFE tube and then place back the funnel on the PTFE tube. Sometime this happens with PLA too, but moving it solves.
0
Reply
Print Profile
OFFICIAL - 0.2mm layer
Trop grand diamètre si les bobines ne sont suffisamment entamées.
0
Reply
Print Profile
OFFICIAL - 0.2mm layer
1
Reply
Print Profile
OFFICIAL - 0.2mm layer
1
Reply
Print Profile
OFFICIAL - 0.2mm layer
1
Reply
Print Profile
OFFICIAL - 0.2mm layer
1
Reply
Print Profile
OFFICIAL - 0.2mm layer
1
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld