This small photograph holder contains a simple pinching mechanism to securely hold your pictures for display.
This print comes in two components, the base and the pinch. Both print easily with no supports. Once you have both printed, simply insert the pinch into the bottom of the base, with the flat part to the bottom, and you're done!
Optionally, the base comes with two recessed areas on the bottom for small circular 8x3mm magnets, so you can use these on any magnetic surface, even upside down.
Depending on the filament you use, the pinch may lose its tension over time, but this part is easily replaceable. Just take any object bigger than the jaws of the pinch, and force it out of the base to be replaced.