Simple coasters with storage by Preischl 3D

Preischl 3D

Household>Decor

Print Profile(3)

All

X1 Carbon

P1S

P1P

X1E

[PLA] 0.24mm - 6x HexCoasters

3.4 h

1 plate

4.3(9)

[PLA] 0.24mm - Horizontal Stand

34 min

1 plate

5.0(1)

[PLA] 0.24mm - Vertical Stand

35 min

1 plate

Boost

Released

Description

Do you like my designs? I would be happy if you would support me by joining my Printables club! :) (already from 3$) It also gives you access to exclusive models ;) https://www.printables.com/@Preischl3D
Or do you want a sales licence? Then you can book the commercial tier!

All models I publish are tested by me and my community before I publish them.

Easy to print and perfect for any household.
The simple design not only looks good, but also catches liquids well and is easy to clean.

In addition, there is the practical storage, which can hold 6 coasters each.

Comment & Rating (11)

@bookis.worthy

Print Profile

[PLA] 0.24mm - 6x HexCoasters

it’s not clear what caused these to barf so badly, but we did notice that even early on, all of the coasters had the same areas with missing filament so possibly there are some design flaws. wish I had trialed this with just one before wasting time and filament.

The designer has replied

@Aruba3D

Hi mate, other people have printed this profile without any problems. Possibly your problem is in the build plate. It should be cleaned regularly to remove grease residues from our hands and ensure a perfect grip. Sorry for the waste of filament and time but I'm pretty sure the problem is what I've told you above. I hope you will be able to print the model correctly in the future :D