Six Pack Can Holder Beer or Soda TPU and PLA or PETG by nbloedel

nbloedel

Household>Other House Models

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

2.6 h

2 plates

3.5(2)

Boost

Released

Description

This 3d printed six pack can holder works great! It took me multiple tries to get the cans to hold in good and tight but as you can see in the video, they now hold in very tight and are still easy to put cans in and remove them.

I printed this in 95a TPU and PLA for the handle.

PETG may be a better choice for the handle but so far I have had no issues.

Handle prints laying down and slots into the 2 handle base pieces.

The handle bases go through the TPU and then the handle slots into the bases.

When assembling make sure the beveled part of both the TPU and the bases is facing up, it is for easier assembly and on the TPU the cans just snap in better.

Comment & Rating (6)

@user_511387828

The handle and the handle holder are here, but the rest of the can holder is not in the project.

The designer has replied

@nbloedel

I will double check it. sorry about that

@nbloedel

If you use my print file to open it, it was there. I have now added the raw file also for download. Sorry I must have forgot to add it when uploading. Thanks for pointing it out

@user_1636661489

Print Profile

0.2mm layer, 2 walls, 15% infill

tolerances are a little tight for beer cans but after a few uses it stretches out and works well enough.

The designer has replied

@nbloedel

that was intentional, when made looser they would only remain tight for 1 or 2 uses then cans would just fall. I use mine almost every week and it's still holding strong. Thanks for the review.