Sagrotan No Touch Refill Cover Cap
Copyright Claim
Sagrotan No Touch Refill Cover Cap
Boost
22
33
36
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
27 min
1 plate
Boost
22
33
36
0
133
223
Released
Description
Tired of buying new Sagrotan No Touch bottles when they are empty?
Why throwing away the old one and produce a lot of waste and cost?
Just print this easy refill cap, cut a hole into the soap bottle and you are done!
You can use a sharp knife or a (not too small) drill.
Take a look at my other multicolor Sagrotan No Touch cap model with a nice logo on it.
Comment & Rating (36)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
Top. Druckt schnell, sauber. Passt. Nur hab ich kein Loch mit einem Messer in meine Flasche bekommen. Das Plastik war zu dick. Mit einem Bohrer gings ;)
(Edited)
0
Reply
Tipp für nächstes mal: Einfach das Plastik vorher warm machen ;)
0
Reply
Replying to @d.j.fpv
Das kommt zu spät, danke aber für den Tipp ♡
0
Reply
perfect fitting. Thanks a lot. 👍🏻
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
fits perfectly
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Sieht aus wie Original.
(Edited)
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Looking good in white silk PLA as if it was OEM. .
The designer has replied
1
Reply
Nice! Do you mind sharing some pictures?
0
Reply
Replying to @Toys_And_Stuff
Still original soap, ugly sticker is removed when refilling.
(Edited)
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Nice perfect size for dethol soap
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Printed lovely from the offset. fits nice
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Fits perfect. Thank you!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
passt
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
ja sehr sehr gut sehr schön
super weiter so
danke
(Edited)0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld