Battery tray / holder AA / AAA / 14500
Boost
30
64
23
Print Profile(1)
0.3mm layer, 2 walls, 15% infill
6.2 h
1 plate
Boost
30
64
23
0
185
114
Released
Description
You can print models while standing.
No supports are needed and it is printed nicely using a 0.3 mm layer height.
Mount on a wall or place on a shelf. Always remove the one that was inserted as the oldest.
Comment & Rating (23)
All
Looks great.
The designer has replied
0
Reply
Printed perfectly fine. No jamming at all due to smart design :)
The designer has replied
0
Reply
Thanks!
0
Reply
Print Profile
0.3mm layer, 2 walls, 15% infill
these things are the best
0
Reply
Print Profile
0.3mm layer, 2 walls, 15% infill
very useful, tried colouring in the AA and the AAA with a permanent marker and it stained around but that's on me nothing wrong with the model
0
Reply
Print Profile
0.3mm layer, 2 walls, 15% infill
Printed in PLA. Looks nice and perfectly holds batteries.
0
Reply
Print Profile
0.3mm layer, 2 walls, 15% infill
Printed nicely with no supports, using designer’s profile. These are really tall (~7 3/4 inches) and hold a lot of batteries (24 AAA and 18 AA). I also like that, unlike most battery dispensers, whose towers are just big open caverns that invite batteries falling in crooked, these towers have ribs/notches inside to hold the batteries in position and encourage orderly movement of the stack.
1
Reply
Any chance for a remix of C, D, or 9V?
0
Reply
very well done!
Works like a charm. No stucks at all
The designer has replied
0
Reply
Print Profile
0.3mm layer, 2 walls, 15% infill
Eine gute Arbeit cooles Teil
0
Reply
Print Profile
0.3mm layer, 2 walls, 15% infill
De coña baterías organizadas
0
Reply
Print Profile
0.3mm layer, 2 walls, 15% infill
had to split the print in height, then glued the top, works like a charm
0
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRemixes (2)
© 2024 MakerWorld