Hi, Brim should not be needed. Do you by the way remember to use Glue stick on the cool plate for good adhesion ? Support will result in a better print, so I will update the profile with support to get a better print result of the pins.

Bambu lab states that we need to use glue stick as a plate releasing agent not for better adhesion. The plate as it is, without glue stick on it's got way to much adhesion ( I know because i tried it :) ). To answer your question, i did use glue stick on the plate but with not too much luck as I said, the print came loose after a few layers. I do recommend you add the brim in your profile for a safer use. Thank you

You are correct. I have misinterpreted the documentation and forums from the past. I had good experience using a thin layer for adhesion on my prints, but as that might not be the intended use I'll add a brim to the profile as well for safe measures.

@emersonsilva.2677 make sure to prepare your build plate for proper bed adhesion. A thin layer with a glue stick is always recommended to ensure printbed adhesion. The handles can be printed separately as the file and print profile for the handle is added in separate profiles.