Simple 10cm RISER hinged doors with magnets

Print with PETG, ABS or ASA
Nozzle 0.4
Layer height 0.24
Walls 4
Infill 15%-25%

------------------------------------------------

Hardware:

6x magnets, diameter 8mm x 3mm height
6x M3x40mm hex screws
plexiglass 2mm thick
Superglue

-----------------------------------------------

Assembly:

1. Assemble the 4 part frame
2. Insert 3 magnets in designated holes in the centre (use superglue)
3. Assemble Doors with Facets, use M3x40mm screws
4. Insert 3 magnets in doors (use superglue)
(check the orientation of each magnet so they don't repel on the frame)
5. Cut plexiglass to fit in all 3 doors
6. Superglue plexiglass on doors
7. Superglue Facets with Doors on the Frame, three sides
8. Take off the glass from the top of the printer and put it on the frame
9. Mount the new frame on top