This mount will let you mount the BondTech extruder with a E3D (or clone) Hot end on your Taz 4-5 so that its and direct drive set-up.

All you have to print are the two pieces.
Heat up the nut inserts from your old fan mount holder and pull them out, and reheat them and press them into the new printer mount

i used two 10-24 1.5" screws and nuts too mount the extruder should be able to use m6 also with an Allen head

Wiring.
you need 12v for the fan on the hot end.
rewire the wires for the thermostat
rewire the wires for the stepper motor

firmware.
need to set reset/ calibrate the estep. (Mine was 492.45)

after you get it all set up you have to reset you z home offset

Print instructions

Category: 3D Printer Extruders Summary

This mount will let you mount the BondTech extruder with a E3D (or clone) Hot end on your Taz 4-5 so that its and direct drive set-up.

All you have to print are the two pieces.
Heat up the nut inserts from your old fan mount holder and pull them out, and reheat them and press them into the new printer mount

i used two 10-24 1.5" screws and nuts too mount the extruder should be able to use m6 also with an Allen head

Wiring.
you need 12v for the fan on the hot end.
rewire the wires for the thermostat
rewire the wires for the stepper motor

firmware.
need to set reset/ calibrate the estep. (Mine was 492.45)

after you get it all set up you have to reset you z home offset

Print Settings

Printer: Da vinci 1.0

Rafts: Doesn't Matter

Supports: Doesn't Matter

Infill: 35-50