Dragon pencil holder
Boost
50
74
11
Print Profile(3)
0.16mm layer, 2 walls, 10% infill
Designer
37 min
1 plate
Toothless colors 0.2mm layer, 2 walls, 10% infill
Designer
2.1 h
1 plate
Valentine's color set 0.2mm layer, 2 walls, 10% infill
Designer
3.8 h
1 plate
Boost
50
74
11
0
88
69
Released
Description
Looking for a small model to bump up the cuteness of your deskspace? this cute little dragon will hold one of your pencils for you, keeping it safe so it is never lost.
Print in place little dragon pencil holder; studio will say the eyes need support - they do not. However, if the model is enlarged past acceptable bridging, they might.
***This is not to be a tight hold on a pencil or pen, just a cute desk object to place it in. It is made to lay on a flat surface.
Comment & Rating (11)
All
Print Profile
0.16mm layer, 2 walls, 10% infill
This thing is adorable and printed great!
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
Good pencil holder
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
It was too big for any pencil or pen in the house
The designer has replied
0
Reply
Did you make it bigger? it is not supposed to be a tight hold, a pencil or a pen just rests in the spot...
0
Reply
This thing is adorable and looks great in chameleon filament!
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
hat alles super geklappt. habe für die Oberfläche noch die Oberfläche gebügelt
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
Kids love them. Only "complaint" was that the pencil was not a "push fit" into the slot
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
cute!
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
0
Reply
Print Profile
Toothless colors 0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 10% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld