If you like my work and want to support me - please print my “Designer” printprofiles! Thank you in advance!🙏😍

I think the silica boxes in AMS are simply brilliant, so the filaments can stay in AMS for a long time and be kept dry for a very long time! The silica gel can simply be dried in oven or microwave and used again - top!

I like to use the boxes from STprinting for middle niches🙏. I also designed these beautiful boxes for narrow sides/corner niches on the far left and far right in AMS! 😍

Why this Version of the lid with handle?

But, have you tried to get the boxes out of AMS niches again? This is very difficult because they have no handles.

I don't like the idea of the handle on the box itself. It will collide with AMS housing/parts and not really easy to print without supports.

But why not to put the handles on the lid? Easy to print, you don't need to reprint whole box, only lid and it looks really cool!

My only fear was that the box would open when I pulled the lid. That's why I made the side where the handle is, thicker with an extra “snap bar”. Now it is practically impossible to open the box on the handle side, only at the front. Which is a nice safety feature! 👌👍       How to properly handle this - in this 1,5 min Video!

A beautiful bamboo logo fits perfectly on the handle and there is a small grip-bar at the bottom, which is very helpful when pulling it out of the AMS.

Print / Install Instructions:

• place them with the logo on the build plate
• first layer line width: 0,37 (0.4 mm Nozzle) (for perfect look of the bambu-logo)
• first layer speed: 10ms-20ms per second (for perfect look of the bambu-logo)
• 2 perimeter, 4 top/bottom layer, 20% infill
• print layer height: 0.2mm and WALL generator: Classic (in this case please no Arachne for perfect look of the bambu-logo) !!!

Cool additional Design for these silica/dry pods:

These funnels are very easily put on instead of the lid (but specifically not as tight as the lid!) and stay on the pods by themselves and can be comfortably held together with the pod on the funnel handle! In addition, the pods can be easily filled to the brim because they are clipped on from the outside. 👌😍👍

— ! —

Thanks for downloading, rating in advance and please don't forget to like this model! ;-)

Take a look at my another very helpful designs for X1/P1P/P1S/A1/A1mini:

If you like my work and want to support me - please follow me and if you want - you can buy me a coffee! https://linktr.ee/eds_3d_shop

Thank you for your support and.. happy printing!

Ed ;-)