eSUN cardboard spool holder WOKR WITH ANY 20cm SPOOL
Remixed by
Copyright Claim
eSUN cardboard spool holder WOKR WITH ANY 20cm SPOOL
Remixed by
Boost
66
125
91
Print Profile(1)
0.28mm layer, 2 walls, 100% infill
Designer
16 min
1 plate
Boost
66
125
91
0
547
1.1 k
Released
Description
MODEL
This is remix of this model: https://makerworld.com/en/models/19118#profileId-24058
I made small changes to adapt more tight, and make it a bit more slimmer, also included .step file with model
Comment & Rating (91)
All
Print Profile
0.28mm layer, 2 walls, 100% infill
Fits nice and snug. Now to run it for a few prints and see how it holds up.
The designer has replied
1
Reply
nice, hope it will work. With Esun spoold works great
(Edited)0
Reply
Print Profile
0.28mm layer, 2 walls, 100% infill
Quick and Easy print. Couple of minutes and you're ready to rumble, without respooling it. ✌️
The designer has replied
1
Reply
Yeah that's what i like on it. Its so slim and eazy to print. Wont take long and waste too much filament. Really happy that this helped you (:
0
Reply
Print Profile
0.28mm layer, 2 walls, 100% infill
Fits perfectly, even on bent cardboard rolls.
(Edited)
1
Reply
Print Profile
0.28mm layer, 2 walls, 100% infill
Worked good on my Inland PLA Plus spools. Now need to find one for my OVV3D spools.
1
Reply
Print Profile
0.28mm layer, 2 walls, 100% infill
works nicely! this design is one of the thinnest I’ve seen and works well in my AMS. a few other designs from others rub on the top of my AMS
(Edited)
0
Reply
Print Profile
0.28mm layer, 2 walls, 100% infill
print is good...
BUT: spool w/this bezel doesn't fit inside AMS. the lid doesn't close
The designer has replied
1
Reply
thats odd, for me fits perfectly in ams.
0
Reply
try this one
https://makerworld.com/zh/models/33133#profileId-29934
0
Reply
Print Profile
0.28mm layer, 2 walls, 100% infill
Sadly, the cardboard on my spools had already degraded from a previous printer, but these still came in handy to make it just stable enough to print!
The designer has replied
1
Reply
nice, really happy that this helped you out
0
Reply
Print Profile
0.28mm layer, 2 walls, 100% infill
Broke some Adapters. Some spools seem bigger than others.
0
Reply
I have had that same problem I still dunno how to fix it
0
Reply
Print Profile
0.28mm layer, 2 walls, 100% infill
Unfortunately it hits the lid of the AMS. I have to print with the lid slightly open.
1
Reply
Print Profile
0.28mm layer, 2 walls, 100% infill
printed fine sometimes can slip off the roll
1
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld