I designed a wallmount system for sodastream bottles. You can mount as many bottles as you like:

• Print the right and the left ending. These are wallmounted and connected at the very end of the left and right bottleholder.
• Print at least one bottle holder. These can be connected together with other bottleholders.
• Print a middle piece for stabilization if you need it. You can connect them whenever you like.
• Print as many hole caps as you need. At least two for the right and the left ending.

I also created two different type of models:

• without Cap Holder
• with Cap Holder (the caps can also slide in the same way as the bottle

Attention:

• All Print Profiles contain both models. So choose the desired model and print the plate of your choice. The first one is always without the cap holder. Even if you use that there is a way to hold the caps. Just have a look at the “cap fixed” picture below then it is getting clearer (btw → you can also use that method with the cap holder model).

• Use a filament where you know it does not break easily. You can test the strength of the filament by just turning the bottleholder the other way round and insert a bottle while you move it. With usual PLA there should be no problem. My Bambu Sparkle PLA broke immediately.

You can use the Cap-Less System also the other way round and assemble the cap after the bottle has its final position. This way you can also fix the bottle. But remember to remove the cap again before pulling the bottle out of the holder ;)

This is the usual way:

This is the “cap fixed” way (the bottle is fixed and can't be moved when the cap is installed completely):

You can also use the model with the cap holder and use it the unusual way with a completely installed cap. This is also possible with the cap-less model but there it is a bit more shaky because it's not as high as the model with cap holder:

Have fun with it :)

BR

B@sti