PTFE cable chain clip for P1P/P1S and X1C
Copyright Claim
PTFE cable chain clip for P1P/P1S and X1C
Boost
455
940
406
Print Profile(4)
0.2mm layer, 3 walls, 15% infill
Designer
18 min
1 plate
0.2mm layer, 6 walls, 15% infill
Designer
16 min
1 plate
PETG - 0.2mm layer, 3 walls, 15% infill
18 min
1 plate
0.12mm layer, 3 walls, 15% infill
22 min
1 plate
Boost
455
940
406
1
2.8 k
1.9 k
Released
Description
Clips onto the Cable chain very securely and rigidly. Then snap in the bowden tube.
Use pliers to remove the clips by slowly lifting one end from the cable chain.
The clips are very sturdy and dont move much.
Comment & Rating (406)
All
Print Profile
0.2mm layer, 6 walls, 15% infill
Very good
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
prints well, snug fit. so far it looks to keep my ptfe tube from rubbing the upper glass.
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
everything is fine
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Print profile worked well, clips came out great
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
great model fits ith little effort and great for further towards back combined with a different one allowing more movement close to print head
(Edited)
0
Reply
Print Profile
0.12mm layer, 3 walls, 15% infill
Clips 5/5 Sterne, das mal vorweg! Allerdings knickt der PTFE Schlauch direkt aus dem Extruder, wenn man alle 5 in gleichem Abstand anbaut.
Ich habe 2 Weggelassen und die Abstände größer gewählt das passt perfekt!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
semplice ma efficace
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
top notch. thankie kindly.
(Edited)
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
nice! Thanks 🙏🏿
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
perfekkro
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
Related Models
© 2024 MakerWorld