Click Here to check out the updated Version 2 of the "Lid Lift"!

The “Lid Lift” vents the chamber for printing PLA and PETG filament. Fits with and without a lid lifter. See photos!

FEATURES:

• Vents chamber for printing with PLA or PETG
• Designed specifically for those who have the AMS on top
• Protects the glass lid by distributing the weight of the AMS and filament
• Easy to install and remove with AMS on top
• Can be used without an AMS on top as well
• Works with many lid risers (see last photos)
• Simple inexpensive print

Is your AMS on top of your Bambu Printer? Have you been leaving the front door open to vent the chamber? Me too, and I was always worried someone would walk by and hit the front door, breaking it. As seen in the photos, this precision wedge supports the glass from the front all the way to the front feet of the AMS. This supports and protects the glass by distributing the weight of the AMS and up to 4kg of filament! Simple to print and far less expensive than many other solutions. BONUS: Easy to install and remove as needed WITHOUT removing the AMS. NOTE: I recommend NOT using the lid's knob to lift the glass when installing and removing. Instead, from the inside of the chamber push the glass up enough to insert the “Lid Lift”.

CHECK OUT THESE OTHER ACCESSORIES

AMS Buffer PTFE Holder

AMS PTFE Connecting Rod

AMS Filament Pull Back Fix

PTFE Chain Clips

AMS Filament Buffer Release Button

PTFE Guard - Print Head