Model

I created a set of Super Mario characters in watercolor for my son's room. 

One of these characters is Piranah . It is created in Hueforge.

 If you use more than one of my characters, use the same filament for grey, black and white so that all the pictures match each other.

See my other paintings

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
    PLA BambuLab Matte Charcoal Transmission Distance: 0.6
    PLA BambuLab Tough Vermilion Red Transmission Distance: 3
    PLA BambuLab Matte Grass Green Transmission Distance: 2
    PLA META Sunlu Grey Transmission Distance: 5
    PLA Overture Matte Pale Green  Transmission Distance: 3.5
    PLA BambuLab Matte Ivory White Transmission Distance: 4

Swap Instructions:
    Start with Charcoal
    At layer #8 (0.72mm) swap to Vermilion Red
    At layer #10 (0.88mm) swap to Grass Green
    At layer #11 (0.96mm) swap to Grey
    At layer #12 (1.04mm) swap to Pale Green 
    At layer #14 (1.2mm) swap to Ivory White for the rest.

The model is not as tall as your last slider.  Consider checking the Full Range button or change your Depth Mode.