Build Plate Rack Side Panel
Remixed by
Copyright Claim
Build Plate Rack Side Panel
Remixed by
Boost
73
125
43
Print Profile(1)
0.2mm layer, 2 walls, 20% infill
Designer
1.7 h
1 plate
Boost
73
125
43
2
231
158
Released
Description
Side cover for the 10 or 5 plate Build Plate Rack. Uses the existing screw holes in the sides when not using a stand. Designed to be printed multi-color and face down on the build plate. Kept thin to be printed fast without too much filament usage. Just wanted to enclose the sides to make it look a little more complete.
*The flow calibration line will need to be removed from the plate right after it is printed to make room for entire model to fit on the build plate!!!
Comment & Rating (43)
All
Print Profile
0.2mm layer, 2 walls, 20% infill
Pretty good. sadly 101% feet are too tight and make the middle pop so I had to remove them. Maybe in the future Inwill reprint the original feet If I ever get to it as they are not really needed. Great model and the profile works ok with little adjustment but I always touch here and there.
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
printed great
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
could be harder,need more layers.
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 20% infill
Easy to print. Looks great. Fits well.
Thin (and therefore bendy) but saves material.
Thanks for the design!
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
Fixed plate holder to side of my p1s with 3M tape. Looks great!
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
I think it was this plate
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
printed with 0.6mm nozzle @ 0.3mm layer height. awesome. just got some colors in it for some Halloween stuff, guess it looks good. 👍🏻
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
Exactly what i was looking for. Easy to print and looks perfect.
Looks good with the PEO build plate effect.
PS: it would be nice if you can provide an version with a 90° rotated logo
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
looks great!
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 20% infill
Black logo on matte grey
(Edited)
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRemixes (1)
© 2024 MakerWorld