Minion on the front of the extruder. by Wojciech Kawa

Wojciech Kawa

3D Printer>3D Printer Parts

Print Profile(5)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

54 min

1 plate

4.8(113)

Strong top fasteners, 0.2mm layer, 2 walls, 15% infill

Designer

55 min

1 plate

5.0(19)

(Eye Color Correction) 0.16mm layer, 4 walls, 15% infill

59 min

1 plate

4.8(17)

For Generic PLA (blu eye)_0.16mm layer, 2 walls, 10% infill

1.1 h

1 plate

4.9(8)

Click to see more

Boost

437

571

182

1.1 k

762

Released

Description

A Minion on the front of the extruder that rolls one eye while printing.

Minion on the front of the extruder

Please use my profile for printing as I spent some time on it to make sure the print turns out as good as possible.

Let me know if the print was successful and if everything fits. If any corrections need to be made, let me know.
If you have printed it, please leave a rating.
Before installation, the original front and the rotating element must be dismantled.
During installation, the eye should be pressed as far as it will go. After putting the face, the eye should be flush with the face or deeper.
When assembling, make sure that the top latches are flush with the top edge before pressing from the front.

If you think that standard hooks are too weak and may break, print a version with reinforced fasteners.
You will see details in the photos below.

See my other projects.

Assembly instructions below. (same as Funy Face)

Version with strong top fasteners.

Comment & Rating (182)

@RuvimKUB

Print Profile

0.2mm layer, 2 walls, 15% infill

It's an amazing job. I was especially surprised by the author's trick, he made the first layer of one color and the second of another, and due to this, it turned out to mix colors and visually looks like I dreamed of not 4 colors but all 6 ). From the comments, I would like to draw attention to the very thin latches that I accidentally broke off for the first time.

@baby_A1

how does it make the goggles gray and his eye green!?!? I had no idea the A1 mini would/could mix colours! this turned out to be a 6 colour print with only 4 colours on the AMS. amazing print! thank you!

The designer has replied

@WojciechKawa

Thanks for your print. The filaments are slightly transparent in a single layer, I tried to experiment with this in this project. I think I achieved an interesting effect of additional colors.