INVASION! The electric tea light UFO
DrKronos
Shared by
Boost
47
59
7
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
6.1 h
3 plates
Boost
47
59
7
0
85
74
Released
Description
The 10mm diameter, 3mm height magnets to hold the two halves of the UFO together are optional, as a display piece gravity alone should be sufficient.
Use a piece of wire to hold the UFO over the base at a height and an angle you like.
Blender file included.
UFO_top.stl and UFO_bottom.stl will need supports for the cavity holding the tea light.
Tea Light size: 38mm diameter, 20mm height (not counting the flame)
© DrKronos
Comment & Rating (7)
All
Nice print. Ended up cutting up a coat hanger for the wire, think it's a little thick but it works also added a cow and a cotton ball
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
While printing the first parts from prinrables I saw that the model also is available here so I switched over to use the print profiles :) Since I Don have a fitting wire right now I used a remix from printables for that part.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
genau das was ich gesucht habe
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
excelente!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
The user shared this model, but is not the original creator of it.
License
This work is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld