Create some fun in your office with Funky Bendy Pen pots.

Just print 1x Bendy Pot Skin with a 0.2µm layer height. Then choose your favorite shape from the collection print the associated base and lid. Then slot the bendy skin into the base and then slot the lid onto and you have a cool funky pen pot.

This is a remix of @TechingTech flat but bendable models design which is great.

I reduced the height of the flat skin by 0.2mm and printed it in PLA and found that it worked great. All the models you see in the photos are printed with PLA. PETG will also work though.

Fitting the bendy skin into the base and lid can be a little fiddly but it is doable as you can see in the photos. They are stable without glue but if you want to make them more permanent then a little superglue does the trick just make sure you have the model seated in the base fully pushed down or your pot could end up a little wonky.

If you are feeling a little adventurous you can print mismatching bases and lids, I have only tested this with the hexagon and triangle (see blue and orange pot image).

Please note I have tested: Circle, Square, Hexagon, Pentagon, Triangle, Kite, Pentagon

I have not printed or tested the: decagon, dodecagon or star (this could be very challenging), but they should work.

If you fancy a shorter pot reduce the x of the bendy pot skin by the required amount and print, this will reduce the slot holes but it should still work. Note I have not tested this so print at your own risk.