Iowa Hawkeyes Logo - Lightbox
Iowa Hawkeyes Logo - Lightbox
Boost
7
12
3
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
3.5 h
2 plates
Boost
7
12
3
0
32
27
Released
Description
Iowa Hawkeyes Lightbox - add LED strips to the inside.
Comment & Rating (3)
All
As a Hawkeye fan this is perfect. thank you. I had some issues with the brim and getting the brim to come off cleanly. Not the fault of the design but just wondering if there were any tips/suggestions to get a cleaner print.
The designer has replied
1
Reply
getting this one clean was one of the harder models honestly, took a few tries. I think cause it’s just so heavy on the black but not sure!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld